a flat view and a threaded view.

英语翻译
请问the spacing from pits to the edge of threaded holes shall be at least 0.5 mm;这句话中,pits 该如何翻译

英语翻译
The coefficient of friction of threaded fasteners shall be tested per DIN 946 with the following exceptions:
其中 with the following exceptions的意思是：“请遵循以下条款：”
还是“以下条款除外”,
应翻译为：按标准进行测试，遵循以下条款。exception是指以下这些条款不在那个标准里面的意思

英语翻译
In the case of threaded bolts with a thread down to the weld upset,the result may also be regarded as satisfactory if cracks start from the root of the thread.

英语翻译
HILTI Threaded bar HIT-V-R M16x300
Hexagonal flat nut M16 DIN936,AISI 316
Hexagonal nut M16 DIN934,AISI 316
Plain washer M16 DIN9021 or DIN 440,AISI 316
HILTI HIT-RE 500 epoxy resin adhesive system

英文翻译，求懂英文的人进来
要求不能使用翻译工具，自己手动翻译（因为翻译工具翻译的文章读不通。）
Threaded Insert Installation Instructions:
Moses Carbon Graphite USA necks are sold with a mount kit consisting of self-tapping brass threaded inserts and oval-head, Phillips head, stainless steel machine screws. Using standard wood or other inappropriate screws in the installation of your neck will void the warranty.
To install a MOSES neck using the mount kit provided:
1. First place and lightly clamp the neck in the heel pocket. Then mount the outside two strings, bringing them up to light tension. Adjust the neck to alignment, so that these strings are the proper distance from the sides of the fingerboard.
2. Take a drill bit the size of the holes in the body heel pocket. Insert the drill bit by hand into the body pocket holes, and twist it (with pressure applied) to mark the center of the holes to be drilled in the back of the neck heel.
3. Detach the neck from the body.
4. Next, for use of 8-32 screws, mount a 15/64″ (5.95 mm) high speed drill bit in a drill press. Should you have a helper to ‘sight’ the verticality of a high speed electric hand drill, this may be an option. For use of 10-32 screws, use a 19/64″ (7.5 mm) drill bit.
后面还有一点点 字数超了 后追加吧
5. With the neck heel held firmly at a 90 degree angle to the drill bit, drill the holes to a maximum depth of 5/8″ (0.625″/15.87mm) or as appropriate to properly accommodate the depth of the screw without going through the fingerboard area. Drilling through the neck to the fingerboard surface will void the Warranty. Moses recommends that the open surface edges of the holes be ‘chamfered’, as is done after drilling holes in high quality wood necks.