an optimum run rate while meeting the quality criteria of ou

wsttnlm2022-10-04 11:39:541条回答

an optimum run rate while meeting the quality criteria of out
The modules need to be visually inspected via a stereo microscope.Recommended zoom level is 64 although Motorola would consider Samsung recommendation to keep the production at an optimum run rate while meeting the quality criteria of outgoing inspection.其中的Motorola would consider Samsung recommendation to keep the production at an optimum run rate while meeting the quality criteria of outgoing inspection.

已提交，审核后显示！提交回复

ylzhome 共回答了14个问题 | 采纳率100%: Motorola would consider Samsung recommendation to keep the production at an optimum run rate while meeting the quality criteria of outgoing inspection摩托罗拉会考虑三星的建议,生产保持在最佳生产水平,同...; 1年前

从句作状语For each enzyme reaction there is an optimum temperatur 从句作状语 For each enzyme reaction there is an optimum temperature at which maximum efficiency is achieved.请问which 前为什么要加上at? 节肯1年前3: 河口的娃子共回答了23个问题 | 采纳率95.7%

For each enzyme reaction there is an optimum temperature at which maximum efficiency is achieved.
对于每个酶反应有一个最佳温度达到最大的效率.
因为先行词是temperature,在这个度数要用at the temperaturec才对,所以 at which
The vegetables store well at temperature below 20℃.
这些蔬菜在20摄氏度以下能够很好地贮藏.

1年前查看全部

英语翻译Uniform Design was applied to determine the optimum cond 英语翻译 Uniform Design was applied to determine the optimum condition of hot water extraction of polysaccharides from dried Gynostemma pentaphyllum Makino.For Uniform Design and subsequent analysis,the software named as Data Processing System (DPS Version 3.0) was used to generate the experimental designs,statistical analysis and regression model (Tang & Feng,1997).The investigated levels of each factor were selected depending on the above experiment results of the single factor.The combination eﬀect of independent variables X1(solid:liquid ratio,g/ml),X2 (immersing time,min),X3 (water extraction temperature,°C),and X4 (water extraction time,min) at 13 variation levels (Table 1) in the extraction process,is showed in Table 2.A total of thirteen combinations were chosen in random order according to DPS software conﬁguration for four factors.The coded and actual values are also shown in Table 2.The responses functions (Y) were polysaccharides yield.These values were related to the coded variables by a second-order polynomial Eq.(1) below kat2hy1年前1: 海南明珠长城共回答了16个问题 | 采纳率87.5%

可以理解你为什么这么说.这是一片论文摘要.译文如下,
本研究采用均匀设计,用于判定干绞股蓝多糖的热浸提优化条件.试验设计与结果分析使用数据处理系统(DPS 3.0)软件,该软件用于提供试验设计、数据分析及回归模型的建立(Wang & Feng,1997).根据以上单因素试验结果设定每个因素的试验水平.提取过程中独立变量X1(固体：液体比例,g/ml)、X2（浸泡时间,min)、X3（浸提温度,°C）与X4(浸提时间,min)等的组合效果,共13个变量水平(表1）列于表2.根据DPS软件的四因素设计,按随机顺序,共挑取13个组合.其编码值与实际值亦列于表2.响应函数(Y) 即多糖产量.这些数值与以下二次多项式（1）所编码的变量关联.

1年前查看全部

翻译Circuit Simulation of Photovoltaic Systems for Optimum Int 翻译Circuit Simulation of Photovoltaic Systems for Optimum Interface between PV Generator and Grid xy9709231年前1: kajouna 共回答了21个问题 | 采纳率90.5%

为PV发电机与电网寻找最佳接口的光电系统线路模拟.

1年前查看全部

求通信翻译这句话：A Unified Treatment of Optimum Pilot Overhead in Mu 求通信翻译这句话：A Unified Treatment of Optimum Pilot Overhead in Multipath Fading Channels writingpadA41年前1: 曹飒共回答了19个问题 | 采纳率94.7%

对多径衰减信道中的最佳导频开销的统一处理

1年前查看全部

英语翻译1 mL of anti-CLE pAb and anti-RAC pAb at the optimum con 英语翻译 1 mL of anti-CLE pAb and anti-RAC pAb at the optimum concentration of 40 and 50 μg mL−1 were incubated with 10 mL of colloidal gold solution (pH 9.2) for 30 min at room temperature,respectively. goodjh11291年前4: asjkdfeiruiofgj 共回答了17个问题 | 采纳率94.1%

一反CLE的PAB和反RAC的PAB中在40毫升的最佳浓度.
毫升50微克- 1,用10胶体金溶液30分钟,室温下分别为（pH值9.2）mL的培养.

1年前查看全部

英语翻译The optimum conditions for the production of amorphous S 英语翻译 The optimum conditions for the production of amorphous SiO2 nanowires are:an atmosphereof Ar (51.99 kPa) and O2 (1.33 kPa),at 1300215003 and in the presence of TiSi covering Tifoil.But before heating to its melting point,a decompose reaction for TiSi takes place at a pressureof Pθ,according to this reason we here advance a plausible partial explanation of these resultsinvolving a thermal decompose reaction of TiSiTiSiTi+Si (1)leading to the formation vapor Si.The Si then immediately reacts with O2 to form SiO2 at the experimentaltemperature:Si+O2SiO2 (2)Fig.1.Design of the chamber for the heating experiment.No.4 A NOVEL CHEMICAL ROUTE TO SiO2 NANOWIRES 391Fig.2.(a) White product growing on the Ti foil surface,(b) large quantities of the nanowires of smooth surface and uniformdiameter,(c) HRTEM image of the nanowires,(d) EDX analyses of individual nanowire.The SiO2 from eq.(2) condense solid SiO2 .As long as nuclei formed,i.e.shorter nanowires,thermalflow occurs along the nanowire axis,hence the nanowire growth continues along thisnanowire axis.So heat is dissipating along a and c axes[8] (fig.3(a)),so that this growth processremains thermodynamic balance.Finally,the very long SiO2 nanowires are formed.The amorphousSiO2 nanowires are believed to form by chemical reactions and analogous growth mechanismsinvolving a vapor-liquid-solid process.Fig. susan06121年前4: QQ339582085 共回答了18个问题 | 采纳率94.4%

The optimum conditions for the production of amorphous SiO2 nanowires are:an atmosphere of Ar (51.99 kPa) and O2 (1.33 kPa),at 1300 1500 and in the presence of TiSi covering Ti foil.
生产非晶SiO2纳米线的最佳条件是：环境为Ar（51.99 kPa）,O2（1.33 kPa）,1300 1500 ；且有TiSi覆盖钛箔.
But before heating to its melting point,a decompose reaction for TiSi takes place at a pressure of Pθ,according to this reason we here advance a plausible partial explanation of these results involving a thermal decompose reaction of TiSiTiSiTi+Si (1) leading to the formation vapor Si.
但在加热到其熔点之前,当压力为Pθ时发生了TiSi的分解反应,据此,我们在此对这些结果提出一个合理的局部解释,这些结果涉及导致形成气相Si的TiSiTiSiTi+Si (1)的热分解反应.
The Si then immediately reacts with O2 to form SiO2 at the experimental temperature:Si+O2SiO2 (2) Fig.1.Design of the chamber for the heating experiment.No.4 A NOVEL CHEMICAL ROUTE TO SiO2 NANOWIRES 391
之后,Si立即与O2反应,并在实验温度下形成SiO2：Si+O2SiO2 (2) .图1---加热试验的箱室设计.第4：获得/制备SiO2纳米线391的一种新化学路线.
Fig.2.(a) White product growing on the Ti foil surface,(b) large quantities of the nanowires of smooth surface and uniform diameter,(c) HRTEM image of the nanowires,(d) EDX analyses of individual nanowire.
图2（a）在钛箔表面生长的白色生成物,（b）大量表面光滑且直径均匀的纳米线,（c）纳米线的HRTEM图像,（d）单个纳米线的EDX分析.
The SiO2 from eq.(2) condense solid SiO2.
从式(2)浓缩固体SiO2得到的SiO2.
As long as nuclei formed,i.e.shorter nanowires,thermal flow occurs along the nanowire axis,hence the nanowire growth continues along this nanowire axis.
由于形成了核（即较短的纳米线）,沿纳米线轴线就出现了热流量,因而纳米线的生长得以沿该纳米线轴线继续.
So heat is dissipating along a and c axes [8] (fig.3(a)),so that this growth process remains thermodynamic balance.
因此热量沿a、c轴线消散[8]（图3（a））,以便使这一增长过程保持热力学平衡.
Finally,the very long SiO2 nanowires are formed.
最后,形成了很长的SiO2纳米线.
The amorphous SiO2 nanowires are believed to form by chemical reactions and analogous growth mechanisms involving a vapor-liquid-solid process.
通过化学反应和同功生长机制（包括气态-液态-固态过程）形式非晶SiO2纳米线得到证实.

1年前查看全部

an optimum run rate while meeting the quality criteria of ou

共1条回复

相关推荐

大家在问