英语翻译Description for changing the left and right position fro

英语翻译
Description for changing the left and right position from the stepper motor
WT 365.0.0.without the protection cover
2.we lose this lock
3.we screwed this bolt in this axis.
4.we pushed the axis out .
5 we pushed this guide out .
6 we pushed "f3" and stepper motor made a reset .
7.The position of stepper motor after the reset
8.we go in the handling of the machine .we pushed "enter"
9.we pushed "shift and F1"
10 we arrived in the working mode .
11 we pushed the >7times .
12 we arrived in the position for switch OFF the connector -control .
13.we go in with the password '100"
14 .we changed the connector control from "ON" to "OFF"
15.we go out with "ESC".
16 We started the machine with "F1"
17.The machine goes in the loader position.
18 we push the button" <"
19.The machine arrived in the first crimping postion
20 The plunger isn't in the correct control position.
21.To push "<"any times
22.The machines arrived in the correct control position
23To push the "emergency stop " the machine cut the air pressure.
24 we moved the cylinder A0.0.to the back side
25 The machine was in the check position.
26 we installed in the calibre in the centring bar .
27 we installed in the calibre in the centring bar
28 The calibre was in the good position in the machine .
29 we pushed down the cylinder Ao.1
30 The plunger goes in the calibre on the left side we need o,4mm and on the right side we needed 0,64mm.(We can found this in calibre description in the operating manual)